Chamberlain HS670 - Manual (Page 8)

8
NOT FOR USE AS PEDESTRIAN PASSAGE! This operator is
intended for vehicular use only. To prevent INJURY to pedestrians,
a separate pedestrian access should be supplied, visible from the
gate. Locate the pedestrian access where there is not a chance of
INJURY at any point during full movement of the gate.
WARNING SIGN PLACEMENT
Moving Gate Can Cause
Injury or Death
KEEP CLEAR! Gate may move at any
time without prior warning.
Do not let children operate the gate or
play in the gate area.
This entrance is for vehicles only.
Pedestrians must use separate entrance
SAFETY PRECAUTIONS FOR OPEN ROLLER GATES
AND ORNAMENT “GRILL TYPE” GATES
To prevent SERIOUS INJURY or DEATH from a moving gate:
• Install Warning signs on EACH side of gate in PLAIN VIEW.
• Permanently secure each Warning sign in a suitable
manner using fastening holes.
• Do NOT mount accessories that are accessible through
gate.
• Injuries occur when people get their hands or feet caught
between the top or bottom of the gate and the gate roller.
These potential pinch-points should be guarded against at all
times. Enclosed style gate tracks are available for refitting of
these rollers from many fence suppliers. Also, roller guards
are available for installing over the rollers.
• UL325 requires that, when used, contact sensors shall be
located at the leading edge, trailing edge, and be post
mounted both inside and outside of a vehicular horizontal
slide gate. Non-contact sensors such as photo eyes must
protect during both open and close gate cycles.
• Injuries occur when people put their hands and arms
through openings in the grill while the gate is operating.
They cannot retract their arm and it gets caught between the
moving gate grill and the stationary fence post or fence. This
potential hazard can be averted by placing a 4' screen mesh
on the gate to prevent access through openings anywhere
the gate may travel. See Safety Brochure for details.
To prevent entrapment injuries, mount controls at least 6'
from the gate or any moving parts of the gate. ATTENTION
AVERTISSEMENT AVERTISSEMENT
AVERTISSEMENT
WARNING WARNING
CAUTION
WARNING
WARNING
PRECAUCIÓN ADVERTENCIA
ADVERTENCIA ADVERTENCIA
ATTENTION
AVERTISSEMENT AVERTISSEMENT
AVERTISSEMENT
WARNING WARNING
CAUTION
WARNING
WARNING
PRECAUCIÓN
ADVERTENCIA
ADVERTENCIA ADVERTENCIA
O P E R A T O R W A R N I N G S
Gate Edge on
Rear of Gate for
Open Direction
Gate Edge on Fence
Post for Open Direction
Gate Edge on
Leading Edge of Gate
for Close Direction
Photo Beam
for Open
Direction Photo Beam for
Close Direction
UNIT
Additional Post Mounted Gate
Edge for Close Direction Additional Post Mounted Gate
Edge for Open Direction
Pinch-Point
Hazard
Pinch-Point
Hazard
Gate Edge for
Close Direction
Gate Edge for
Close Direction
Gate Edge for
Open Direction
Always Test Gate Edges and
Photo Beams Anytime They Are
Adjusted or Serviced
Gate Edge
Vertical Post Placed on
Both Sides of the Exposed
Rollers Can Prevent Hands
From Reaching These
Pinch-Points
Open Gate Edge Open Gate Edge
Close Photo Beam Open Photo Beam
OR OR
Unit