Bissell 60A4 - Manual (Page 10)

10
w w w . b i s s e l l . c o m
Dust bag replacement continued
5. Slide the new dust bag into the holder by inserting
the dust bag into the tabs located at the bottom
of the holder. Then press the dust bag holder clip,
insert the dust bag and release the dust bag holder
clip to hold the dust bag in place.
6. Place holder and new dust bag back into
the dirt cup/dust bag compartment, making sure
the entire bag is tucked in below the seal gasket.
7. Close dirt cup/dust bag compartment door and
press down gently until it locks into place.
notE: the dust bag compartment door will
not close without the dirt cup or a dust bag
in place.
Cleaning the pre-motor filter
the pre-motor filter protects the motor from
dirt and dust particles.
1. Unplug the vacuum from electrical outlet.
2. Open the dirt cup/dust bag compartment
by lifting up on the latch on the door at the
front of the vacuum. Lift out the dirt cup or
dust bag holder and dust bag.
3. Remove the filter frame from the filter holder
by grasping the lip of the frame and pulling
up.
4. Remove the filter from the filter frame and
clean by hand washing in warm water. A mild
detergent can be used if desired. Allow the
filter to air dry thoroughly before replacing.
5. Place the filter back into the filter frame and
replace back into the filter holder.
notE: the filter frame should be placed so
the protective frame is visible.
6. Place the dirt cup or dust bag holder and
dust bag back into the dirt cup/dust bag
compartment. If using a dust bag, make sure
the entire bag is tucked in below the seal
gasket.
7. Close dirt cup/dust bag compartment door
and press down gently until it locks into
place.
M
aintenance and care
Washable Pre-
Motor Filter
notIcE:
this product is intended for household
use only and not for commercial or
industrial use. vacuuming of dust
from products like plaster, concrete or
ashes will damage the motor and void
the warranty.
Tip:
For maximum cleaning performance,
check the filters often and clean or
replace if necessary.
WARnInG:
Do not operate cleaner
with damp or wet
filters or without all
filters in place.
3.