Bissell 60A4 - Manual (Page 9)

9
w w w . b i s s e l l . c o m
M
aintenance and care
Emptying the dirt cup
1. Unplug the vacuum from electrical outlet.
2. Open the dirt cup/dust bag compartment
by lifting up on the latch on the door on the
front of the vacuum.
3. Lift the dirt cup assembly out from the vacuum.
4. Remove the top cover from the dirt cup
assembly by unfastening the latch, raising the
front edge and removing the top cover off of
the rear hinges. Set the top cover aside.
5. Empty the dirt into a garbage container.
6. To reattach the top cover on the dirt cup,
align the slots on the top cover with the
hinges on the dirt cup and rotate the front
cover down to the closed position. Then
fasten the latch.
7. Place the dirt cup back into the vacuum.
8. Close dirt cup/dust bag compartment door and
press down gently until it locks into place.
notE: the dust bag compartment door will not
close without the dirt cup or a dust bag in place.
Dust bag replacement
1. Unplug the vacuum from electrical outlet.
2. Open the dirt cup/dust bag compartment
by lifting up on the latch on the door on the
front of the vacuum.
3. Lift out the dust bag holder and dust bag.
4. Release the dust bag from the holder by pressing
the dust bag holder clip and pulling the dust bag
out of the holder. Discard the used dust bag.
2.
4a. 4b.
6.
3.
4.
WARnInG:
to reduce the risk of
electric shock, turn
power switch off and
disconnect plug from
electrical outlet before
performing maintenance
or troubleshooting
checks.