Bissell 60A4 - Manual (Page 5)

5
w w w . b i s s e l l . c o m
A
ssembling your vacuum
1. Connect swivel hose by squeezing both locking
buttons and inserting it into the suction opening on
the canister. Once the swivel hose is inserted in the
suction opening, release the locking buttons.
2. Connect telescoping extension wand to the handle
end of the flex hose. Twist slightly to tighten.
3. Connect floor nozzle to the end of the telescoping
extension wand. Twist slightly to tighten.
4. Once assembled, you can store your
vacuum in one of two positions:
A. Storing in the in-use position:
1. To store with the floor nozzle attached,
insert the storage clip (located on the
back of the floor nozzle) into the
storage slot on the rear of the vacuum.
2. To store without the floor nozzle
attached, insert the storage clip (located
on the bottom of the telescoping
extension wand) into the storage slot on
the rear of the vacuum.
b. Storing in the upright position:
1. To store with the floor nozzle attached,
stand the vacuum in the upright position
and insert the storage clip (located on the
back of the floor nozzle) into the storage
slot on the bottom of the vacuum.
2. To store without the floor nozzle attached,
stand the vacuum in the upright position
and insert the storage clip (located on
the bottom of the telescoping extension
wand) into the storage slot on the bottom
of the vacuum.
b2.
1.
A1.
Storing in the in-use position
Storing in the upright position
3.
b1.
2.
A2.
WARnInG:
Plastic film can be dangerous.
to avoid danger of suffocation,
keep away from babies and
children.