Bissell 4757e - Manual (Page 9)

w w w. b i s s e l l . c o m
9
M
aintenance and care
T
roubleshooting
4. Tap the dirt cup filter assembly over
a rubbish bin to remove any dirt or
debris from the dirt cup filter screen
that surrounds the dirt cup filter.
5. Reach up into the dirt cup to clear
any dirt or debris from the dirt cup.
6. Check to see if there are any clogs
in the suction inlet.
7. After clearing any dirt or debris from the
dirt cup, replace the dirt cup filter assem-
bly back in the dirt cup following step 8
of Cleaning the dirt cup filter on page 8.
the Wide Pet turbobrush™ tool
should be checked regularly for clogs
or debris wrapping around the brush.
1. Unplug the vacuum from the outlet.
2. If the clog is present or debris is visible,
turn the collar on the neck of the Wide Pet
TurboBrush™ Tool counterclockwise to the
unlocked position to remove the faceplate
and clear any obstructions.
3. To clean debris from the brush, remove the
brush from the drive belt and clean debris.
4. Reposition the drive belt on the brush. Place
the ends of the brush in the slots on the
sides. Reposition the faceplate and turn the
collar clockwise to the locked position.
Vacuum cleaner won’t run
Possible cause Remedy
1. Vacuum cleaner is not plugged in 1. Check electrical plug
2. Power button is not pressed down 2. Press power button down
Vacuum cleaner won’t pick up or low suction
Possible cause Remedy
1. Tools, hose and/or extension wands are blocked 1. Remove each part and check for
blockages
2. Filters are dirty 2. Check and clean or replace all filters
3. Dirt cup is full 3. empty dirt cup
4. hose connector not securely attached to suction inlet 4. make sure hose connector is locked
into suction inlet
WaRning:
To reduce the risk of electric shock
or injury, turn power OFF and dis-
connect plug from electrical outlet
before performing maintenance or
troubleshooting.
Maintaining the Wide Pet turbobrush
™
tool
clearing clogs from the dirt cup continued
Wide Pet
TurboBrush™ Tool