Dustless DustBuddie User Manual

Installation instruction, Installation steps, Warning

Advertising
background image

Installation Instruction

DUST COLLECTION SYSTEM FOR RIGHT ANGLE GRINDERS

1. Loosen band clamp.

2. Slip around grinder’s collar.

3. Center DustBuddie on the arbor

and tighten band clamp.

4. Install grinding wheel.

(Use the washers provided to adjust

wheel slightly below the brushes. You

may also adjust the 3 screws if needed)

5. Insert hose to port. Secure other end of hose to

the electric cord with releaseable tie provided.

Go to www.dustlesstechnologies.com for

more installation videos and tips

800.568.3949

dustlesstechnologies.com

Includes:
1 Clear polycarbonate

shroud w/brackets
and clamp

1 18” Flexible Hose
4 Washers
1 Removable clip
1 Releasable tie

Installation Steps:

1. Tighten all 3 screws until bracket touches shroud.
2. Remove brushes. In the brush groove there is a plastic

thin rib that will have to be cut out in order to snap
coverplate in place.

3. Remove shroud clip, trim with band saw or cutting blade

as follows:
a. Trim on “Cut line 1” if cutting blade is directly in front

of grinder

b. Trim on “Cut line 2”, if cutting blade is at a 45° angle

4. Install cutting wheel using washers provided to center

the wheel

5. Snap cover plate in place (not included with grinding kit)

This product was inspected and
packaged carefully before being
shipped from the factory. If you
should happen to need assistance
during assembly or operation, call
1-800-568-3949 for our customer
service department.

Always make sure grinder is UNPLUGGED when removing or attaching front nose clip. Before use, refer to your tool manual for warnings and instructions.

WARNING

Instructions for Crack Chasing/Tuckpointing Application

Cut
Line 1

Cut
Line 2

Advertising