Dustless Dustie User Manual

Installation instruction, Warning

Advertising
background image

800.568.3949

dustlesstechnologies.com

FOR RIGHT ANGLE GRINDERS

2. Cut flanges to adjust height of shroud.

For best dust control, grinding wheel
should be 1/4 inch below shroud.

3. Install grinding wheel. See #2

for height.

5. Install Grinding wheel. For best dust

control, wheel should be 1/4 inch
below shroud.

6. Insert hose to port.

Instructions for Crack Chasing/Tuckpointing Application
1. Trim Flanges to adjust cutting wheel in middle of shroud.
2. Cut the Dustie on "CC Line" or "TP Line" depending on your

desired opening angle. Follow instructions 2-7 above.

3. Snap on Cover Plate* over open face.

*Not Included with all kits

This product was inspected and packaged carefully before being
shipped from the factory. If you should happen to need assistance
during assembly or operation, call 1-800-568-3949 for our
customer service department.

Always make sure grinder is UNPLUGGED when removing
or attaching front noseclip. Before use, refer to your tool
manual for warnings and instructions.

WARNING

4. Tighten band clamp.

Includes:
• Dustie™ shroud
• Band clamp
• Releasable zip tie

1. UN-PLUG GRINDER. Slip shroud

on grinder, flanges should be flush
with attachment.

7. Secure other end of hose to the electric cord with

releaseable tie provided.

Installation Instruction

OM013_0713

Advertising