Install the adam to the monorail (mc-fj-_) – Edge Lighting Adam Pro Aim MR16 User Manual
Page 2
E
5:
louver into the shade.
6: Replace and tighten the lens holder ring to secure the lenses
in place.
Place the lens(es), or a combination of a lens and hexcell
SHADE
LENS
LENS
LENS HOLDER RING
5
2
4:
pen point to loosen and remove the lens holder ring.
From the inside of the shade, use a small Allen wrench or a
D
SHADE
4
SMALL ALLEN
WRENCH
LENS HOLDER RING
6
C
3: ighten the M4 set screw on the front of the shade with the
2mm Allen driver provided.
T
SHADE
2MM ALLEN
DRIVER
M4 SET SCREW
3
F
7:
body and push it completely onto the spring clips until it
snaps in to place properly.
Line up the notch on the shade with the tab on the fixture
SHADE
NOTCH
7
SPRING CLIPS
FIXTURE
BODY TAB
Install the Adam to the Monorail (MC-FJ-_)
HOUSING
CONNECTOR
(DISCARD)
1
G
1: Remove the Monorail housing connector from the Monorail
Fast Jack housing and discard it.
MONORAIL FAST
JACK HOUSING
ADAM HOUSING
CONNECTOR
2: Place the Monorail Fast Jack housing onto the Monorail and
use fingers to tighten the Adam housing connector to the
Fast Jack housing. Make sure that the Adam housing
connector is not cross threaded.
H
MONORAIL FAST
JACK HOUSING
2
2
MONORAIL