Edge Lighting 2 Circuit Out-Riggers - Manual (Page 4)

Install the Monorail 2 Circuit to
Out Rigger Power feed
K 1: Slightly loosen the M5 screw on the bottom of Monorail 2
circuit housing connector, (Do Not Remove) with the
2.5mm Allen wrench.
2: Loosen the two M3 set screws on the Monorail 2 circuit
housing middle contact (Do Not Remove) with the 1.5mm
Allen driver provided.
2.5MM ALLEN WRENCH
3: Slide the Monorail 2 circuit through the opening of Monorail
2 circuit housing connector. Make sure that the Monorail 2
circuit is supported by the Monorail 2 circuit outrigger
standoffs. (Refer to the instructions provided with the
Monorail 2 circuit out rigger standoffs).
4: Adjust the Monorail 2 circuit in the Monorail 2 circuit housing
connector and tighten the M5 screw firmly with the 2.5mm
Allen wrench for proper power connection.
5: Tighten the two M3 set screws firmly on the Monorail 2
Circuit firmly housing middle contact with the 1.5mm Allen
driver for proper power connection.
M5 SCREW
4
1
L
2.5MM ALLEN
WRENCH
M5 SCREW
2 CIRCUIT MONORAIL
1.5MM ALLEN
DRIVER
M3 SET SCREW
OUT RIGGER ARM
2
MONORAIL 2 CIRCUIT HOUSING CONNECTOR
4
MIDDLE CONTACT
1.5MM ALLEN DRIVER
M3 SET SCREW
5
MONORAIL
HOUSING
CONNECTOR