Edge Lighting 2 Circuit Standoffs - Sloped Ceiling - Manual (Page 2)

4
M3 SET SCREW
1.5MM ALLEN
WRENCH
JOINING POST
SLOPED STANDOFF
CONNECTOR
2
2X150 Watt
Sloped Standoff Connector Surface Transformers Installation for
1: See the chart below to determine the joining rod size.
2: Push the joining rod completely into the threaded post and
tighten the M3 set screw with the 1.5mm Allen wrench.
D
M3 SET SCREW
1.5MM ALLEN
WRENCH
JOINING ROD
THREADED
POST
1
E
3
3: Push the joining post half way onto the other end of the
joining rod and tighten the M3 set with the 1.5mm set
screw.
M3 SET SCREW
1.5MM ALLEN
WRENCH
F
JOINING POST
4: Push the sloped standoff connector completely into the
joining post and tighten the M3 set screw with the 1.5mm
Allen wrench.
Install the Monorail to Rigid
Standoff
1: Tighten the rigid standoff threaded post completely onto the
sloped connector threaded post.
G
4
STANDOFF
2X250 Watt
M2T-2X150- 4"
M2T-2X250- 4.8"
Joining Rod Size Model Number Transformer Type
SLOPED CONNECTOR
THREADED POST