Edge Lighting 2 Circuit Standoffs - Sloped Ceiling User Manual
Page 4
4
5: Slightly loosen the M3 set screw on the conical nipple of
each of the standoffs with the 1.5mm Allen wrench so that
the conical nipples can rotate easily.
6: Place the Monorail 2 Circuit into the threaded housings (this
may require more than one person).
7: Tighten the threaded housings to the conical nipples (this
may require more than one person). Make sure threaded
housings are not cross threaded.
THREADED HOUSING
L
MONORAIL
2 CIRCUIT
CONICAL NIPPLE
M3 SET SCREW
1.5MM ALLEN
WRENCH
6
5
7
8: Tighten the M3 set screw on the conical nipples with the
1.5mm Allen wrench.
M
M3 SET SCREW
1.5MM ALLEN WRENCH
8
TAB
ADJUSTABLE
CONNECTOR
9
10
11
N
9: To adjust the standoff height, hold the end of the aircraft
cable while pushing the tab on the adjustable connector
down and sliding the standoff up or down.
10: When desired height is achieved release the tab to lock the
adjustable standoff in place.
11: Trim off excess aircraft cable coming out of the adjustable
connector side hole for a neat finished look.