Edge Lighting Surface Mount Fast Jack Canopies - Manual

FJP-4SF-LED-_
A
1: Loosen and remove the two #8-32 flat head screws from the
canopy to remove the crossbar.
Installation Instructions for
Canopy
4" Fast Jack LED Power Surface Mount
Install the Canopy
1
904-FJP-4SF-LED-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
2: Turn the power to electrical box off.
3: Connect the white LED power supply wire to the neutral
power wire with a wire nut.
4: Connect the black LED power supply wire to the hot power
wire with a wire nut.
5: Place the LED power supply and wires inside the electrical
box.
CROSSBAR
1
#8-32 FLAT
HEAD SCREW
CANOPY
1
© 2009 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.
- Minimum electrical box volume must be 6 cubic inches
(98 cubic centimeters).
- For dimming information visit www.edgelighting.com.
- This product can be used with LED or halogen Fast Jack
fixtures.
IMPORTANT INFORMATION
B
3 4
5
LED POWER SUPPLY