Edge Lighting Fast Jack 26 Port Canopies User Manual
20 or 24 port square fast jack canopy, Install the canopy, Installation instructions for
SAVE THESE INSTRUCTIONS!
FJP-24SQ-_-20W-_
- This product is dimmable with a low voltage electronic
dimmer.
- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.
Installation Instructions for
20 or 24 Port Square Fast Jack Canopy
904-FJP-24SQ-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2011 Edge Lighting. All Rights Reserved.
Install the Canopy
A
1: Remove the sixteen #8-32 screws around the canopy to
remove the mounting plate.
Install the Canopy
MOUNTING PLATE
CANOPY
2:
Align the mounting plate slots with the electrical box holes
and secure it to the electrical box holes with the provided
two #8-32 screws.
Feed the power wires through mounting plate center hole.
3:
4: Tap the anchors through the mounting plate holes onto the
marked point up to the threaded portion with a hammer.
5: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
B
MOUNTING PLATE
#8-32 SCREW
3
2
3
C
MOUNTING PLATE
ANCHOR
#8-32 SCREW
1
1
1
NOTE:
It is recommended that a person to hold the mounting
plate while the electrician installs it.
4
5
NOTE:
All 8 anchors must be installed to balance the pendants
weight.