Edge Lighting Fast Jack 26 Port Canopies User Manual
Page 2
2
D
6: Secure the mounting plate to the anchors with the provided
#8 screws and washers.
WASHER
#8 SCREW
7: Make sure that the mounting plate is grounded in
accordance with local electrical codes.
MOUNTING PLATE
6
E
8
F
MOUNTING PLATE
#8-32 SCREW
11
10: Place all wires and wire nut connections inside the canopy.
11: Place the canopy onto the mounting plate and tighten the
sixteen #8-32 screws.
FAST JACK CANOPY
G
12:
one Fast Jack canopy port.
Use fingers to tighten each Fast Jack fixture connector into
CAUTION: Maximum load of each port is 20 watt. Use
only fixtures that are rated 20 Watt or less, or relamp each
fixture with a Maximum 20 watt lamp.
FAST JACK
FIXTURE
CONNECTOR
12
FAST JACK
CANOPY
PORT
10
11
ELECTRICAL BOX
NOTE:
Make sure a person holds the Fast Jack canopy while the
electrician connects the wires and completes the installation.
8: Connect the Fast Jack white canopy wire to the neutral
power wire with a wire nut.
9: Connect the Fast Jack black canopy wire to the hot power
wire with a wire nut.
9
FAST JACK CANOPY