Edge Lighting 600W/12V Dual Feed Surface Mount Magnetic Transformer - Manual (Page 5)

POWER FEED ROD
2
M3 SET
SCREW
1.5MM ALLEN
WRENCH
BUSHING
5
L
1: Remove the wire nuts from the center wires.
2: Loosen (DO NOT REMOVE) the bottom M3 set screw on
each bushing and carefully pull out the power feed rods
along with the center wires.
Shortening the Power Feed Rod Height
POWER FEED ROD
M
3: From the end of the power feed rods mark each rod to the
amount that needs to be shorten. For example to resize 24"
standoff to 17", mark 7" from the end of the power feed rod.
3
POWER FEED ROD
N
4
4: Use a pipe cutter to cut out the excess rod. If cutting with a
hacksaw, then make sure the center wire is removed from
the rods. To remove the center wire, remove the power feed
cap, pull the wire out. Make sure to clean the burr of the cut
section before re-feeding the center wire.
PIPE CUTTER
POWER HOUSING
5: Feed the center wire through the bushing inserting the
power feed rods completely inside each bushing. Tighten
the bottom M3 set screw with the 1.5mm Allen wrench.
6: Connect each center wire to one loose transformer wire with
a wire nut.
7: Follow the "Install the Canopy" steps on page 1.
POWER FEED CAP
1
POWER FEED ROD
7
M3 SET
SCREW
1.5MM ALLEN
WRENCH
BUSHING
O
6