Edge Lighting 2x150W/12V Dual Feed Surface Mount Magnetic Transformer - Manual (Page 3)

3
10: Feed the extension wires through the transformer housing
center hole. Slide the transformer housing onto the
crossbar assembly nipple and secure it in place by
tightening the washer and inside nut.
CROSSBAR ASSEMBLY
NIPPLE
E
ELECTRICAL
BOX
WASHER
INSIDE NUT
EXTENSION WIRES
HOUSING
10
11: Connect the black and white 120 volt wires from the top
transformer to the one set of black and white extension
wires respectively with wire nuts.
12: Connect the black and white 120 volt wires from the top
transformer to the other set of brown and white extension
wires respectively with wire nuts.
F
13: Hook one of the transformer cover screw holes next to the
rectangle cutout, onto the Monorail feed contact set screw.
G
13
H
2MM ALLEN
WRENCH
14 14
M4 BUTTON
HEAD SCREW
14: Place the transformer cover onto the transformer housing.
Replace and tighten the five M4 button head screws with
the 2mm Allen wrench.
14
MONORAIL 2 CIRCUIT
CONTACT SET SCREW
11
12
TOP TRANSFORMER
BOTTOM
TRANSFORMER
HOUSING
COVER
I
MONORAIL FEED
CONTACT
PLASTIC
INSERT
15
15: Plug the Monorail 2 Circuit feed contacts with the plastic
inserts provided.
NOTE:
disconnected & capped.
The yellow input wires are not used. Leave these wires