Edge Lighting Fast Jack 17 Port Canopies Without Transformers - Manual

SAVE THESE INSTRUCTIONS!
FJC-16RD-_
Installation Instructions for
Canopy Only
16" Round 5, 7, & 9 Port Fast Jack
Running the Power from a Remote Transformer to the
Fast Jack Canopy
1
904-FJC-16RD-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
A
© 2012 Edge Lighting. All Rights Reserved.
1: Run the low voltage wires from a remote transformer to
electrical box where Fast Jack canopy is going to be
installed. It is recommended to install the remote
transformer near the electrical box to avoid voltage drop.
Refer to the instructions provided with remote transformer
for low voltage wire size chart. Refer to the low voltage wire
size chart provided with the remote transformer. REMOTE
TRANSFORMER
ELECTRICAL BOX
CONDUIT
MAX
20FT
- This product is ETL listed for indoor dry locations.
FAST JACK
CANOPY
B
Install the Canopy
#8-32 SCREW
1
1
MOUNTING PLATE
CANOPY
1: Loosen and remove the six #8-32 screws around the canopy
to remove the mounting plate.
1
C
MOUNTING PLATE
#8-32 SCREW
3
2
3
2:
through mounting plate center hole.
Align the mounting plate slots with the electrical box holes
and secure it to the electrical box holes with the provided
two #8-32 screws.
Feed the low voltage coming from the remote transformer
3: