Edge Lighting Fast Jack 17 Port Canopies Without Transformers - Manual (Page 3)

3
H
10 10
9: Make sure that the mounting plate is grounded in
accordance with local electrical codes.
10: Connect each canopy wire to one low voltage transformer
wire with a wire nut.
I
11: Place all wires and wire nut connections inside the canopy.
12: Place the canopy onto the mounting plate and tighten the
six #8-32 screws.
#8-32 SCREW
11
MOUNTING PLATE
CANOPY
12
J
13:
one Fast Jack canopy port. Use fingers to tighten each Fast Jack fixture connector into
FAST JACK
FIXTURE
CONNECTOR
13
FAST JACK
CANOPY
PORT
CAUTION: Risk of Fire: The total load of the Fast Jack
canopy ports should not exceed the remote transformer rated
capacity.