Edge Lighting 17 Port Linear Canopies Without Transformers User Manual

14 or 17 port rectangle fast jack canopy only, Install the canopy, Installation instructions for

Advertising
background image

FJC-33RE-_

Installation Instructions for

14 or 17 Port Rectangle Fast Jack

Canopy Only

904-FJC-33RE-01

IMPORTANT INFORMATION

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

© 2012 Edge Lighting. All Rights Reserved.

1

SAVE THESE INSTRUCTIONS!

- This product is ETL listed for indoor dry locations.

Running the Power from a Remote Transformer to the
Fast Jack Canopy

A

1: Run the low voltage wires from a remote transformer to
electrical box where Fast Jack canopy is going to be
installed. It is recommended to install the remote
transformer near the electrical box to avoid voltage drop.
Refer to the instructions provided with remote transformer
for low voltage wire size chart. Refer to the low voltage wire
size chart provided with the remote transformer.

REMOTE
TRANSFORMER

ELECTRICAL BOX

CONDUIT

MAX

20FT

FAST JACK
CANOPY

1

Install the Canopy

B

MOUNTING PLATE

CANOPY

#8-32 SCREW

1

1

1: Remove the fourteen #8-32 screws around the canopy to
remove the mounting plate.

C

MOUNTING PLATE

#8-32 SCREW

3

2

3

2:

Align the mounting plate slots with the electrical box holes

and secure it to the electrical box holes with the provided
two #8-32 screws.

Feed the power wires through mounting plate center hole.

3:

NOTE:

It is recommended that a person to hold the mounting

plate while the electrician installs it.

Advertising
This manual is related to the following products:
Table of contents