Edge Lighting 17 Port Linear Canopies Without Transformers User Manual
Page 2
2
4: Tap the anchors through the mounting plate holes onto the
marked point up to the threaded portion with a hammer.
5: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
D
NOTE:
All 4 anchors must be installed to balance the pendants
weight.
MOUNTING PLATE
ANCHOR
4
5
E
6: Secure the mounting plate to the anchors with the provided
#8 screws and washers.
WASHER
7: Make sure that the mounting plate is grounded in
accordance with local electrical codes.
MOUNTING PLATE
6
F
8
ELECTRICAL BOX
NOTE:
Make sure a person holds the Fast Jack canopy while the
electrician connects the wires and completes the installation.
8: Connect each canopy wire to one low voltage transformer
wire with a wire nut.
8
#8 SCREW
FAST JACK CANOPY
6
G
MOUNTING PLATE
#8-32 SCREW
10
FAST JACK CANOPY
9
10
9: Place all wires and wire nut connections inside the canopy.
10: Place the canopy onto the mounting plate and tighten the
fourteen #8-32 screws.
H
FAST JACK
FIXTURE
CONNECTOR
11
FAST JACK
CANOPY
PORT
11:
one Fast Jack canopy port.
Use fingers to tighten each Fast Jack fixture connector into
CAUTION: Risk of Fire:
The total load of the Fast Jack
canopy ports should not exceed the remote transformer rated
capacity.