Edge Lighting Vessel 10 Glass User Manual
Page 2
2
E
6: Adjust the fixture height and mark the cord below the
canopy strain relief.
CORD CLIP
CANOPY
STRAIN RELIEF
CORD
6
F
7: Feed the cord inside the canopy so that the marked line
is exposed behind the canopy.
8: Place the cord clip 1" above the marked line by feeding
the cord through the second cord clip hole and pulling
the cord to lock the cord clip in place.
1"
CORD CLIP
CANOPY
STRAIN RELIEF
CORD
8
7
G
9: Slide the canopy up and make sure that the marked line
is right underneath the strain relief. Tighten the strain
relief screw to secure the cord in place.
CORD CLIP
CANOPY
MARKED LINE
CORD
9
STRAIN RELIEF
H
10: Leave 6" of the cord behind the canopy for power
connections. Cut the excess cord.
11: From the end of the cord remove 4" of the cord insulation.
12: Strip 1/4" of the insulation from the wires ends
4"
CANOPY
CORD
11