Edge Lighting Cube-O LED User Manual
Page 3
3
#8-32 SCREW
MOUNTING PLATE
ELECTRICAL
BOX HOLE
1
10
G
10: Mount the mounting plate to the electrical box holes with
the provided two #8-32 screws.
H
BACKPLATE
11
FIXTURE
WIRES
SOCKET PLATE
11: Feed the fixture wires from the socket plate into the
backplate center hole.
12: Connect the backplate ground wire (bare wire) to the
mounting plate. Make sure that the mounting plate is
grounded in accordance with local electrical codes.
13: Connect the white fixture wire to the neutral power wire
with a wire nut.
14: Connect the black fixture wire to the hot power wire with a
wire nut.
I
12
14
13
15: Place all wires and wire nut connections properly inside the
electrical box.
16: Align the two backplate holes with the mounting plate
threaded studs (make sure the gasket is in place) and
secure it in place with the two thumb nuts.
J
THREADED STUD
THUMB NUT
15
16
16
BACKPLATE
K
17: Replace and tighten the two lock washers and nuts to
secure the socket plate onto the backplate.
SOCKET PLATE
NUT
LOCK
WASHER
17
17
BACKPLATE