Edge Lighting Cube-O LED - Manual (Page 4)

M3 SET SCREW
BACKPLATE
19
4
M
19: Align the fixture housing to the backplate (Make sure the
set screw is on top) and push it completely in.
20: Tighten the M3 set screw on the fixture housing with the
1.5 MM Allen wrench to secure in place.
20
SOCKET
21: Push the lamp pins completely into the socket holes.
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
Use MAX 60 Watt Type T4, G9 Base, Bi-Pin
Halogen Lamp.
NOTE: Use only fingers and a soft cloth to install the lamps.
LAMP
N
21
O
22: Align the slots on the glass shade ring with the socket
housing plate tabs. Replace and rotate the glass shade to
lock it in place.
23: For installation in wet location, caulk around the fixture
fixture canopy with waterproof construction sealant.
FIXTURE HOUSING
22
GLASS SHADE RING
TAB SLOT
L
2.5MM ALLEN
WRENCH
M5 SCREW
SOCKET HOUSING PLATE
SOCKET PLATE
18
18
18: Push the socket housing plate slots onto the M5 screws and
tighten them with the 2.5mm Allen wrench.
23