Edge Lighting Cirrus Channel Suspension, Tubular 1" Lens - Manual (Page 3)

3
J
STANDOFF
POST TAB
AIRCRAFT
CABLE
8
8: Push the tab on standoff while feeding the aircraft cable
coming from the channel into a standoff so that it holds one
end of the fixture in place.
8
#8 SCREW
WASHER
W/THREADED
NIPPLE
5
STANDOFF
POST
I
WASHER
W/THREADED
NIPPLE
6
5: Feed the #8 screw through the washer w/threaded
nipple into the anchor.
6: Tighten the #8 screw completely into the anchor.
7: Tighten the standoff posts completely onto the threaded
nipple.
7
9: Feed the coaxial cable through the power feed canopy.
CONNECTOR
ASSEMBLY
COAXIAL
CONNECTOR
COVER
12
COAXIAL
CONNECTOR
COVER
12: Unscrew the coaxial connector covers and remove from the
connector assembly.
NOTE: If cable is curled or kinked, straighten by holding
between the shaft of a screwdriver and thumb and pulling the
cable through (see inset K1)
K
K1
L
1.5MM ALLEN WRENCH 2MM ALLEN
WRENCH
M4 SET
SCREW
M3 SET
SCREW
14
13
13: Using the provided 1.5mm Allen Wrench, remove the M3
set screw from the coaxial connector assembly.
14: Using the provided 2mm Allen wrench to loosen (do not
remove) the M4 set screw.
10: Using the 18 AWG hole of the wire strippers, remove 1" of
the outer braided wire.
11: Using the 20 AWG hole of the wire strippers, remove 1/8"
of inner plastic insulation from the end of the coaxial cable.
BRAIDED
WIRE
INNER
INSULATION
BARE WIRE 1/8"
COAXIAL CABLE
WIRE STRIPPERS
COAXIAL
CABLE
10
M
N
COAXIAL
CABLE
POWER
CANOPY
9
11