Edge Lighting Satin Ceiling User Manual

Page 2

Advertising
background image

ELECTRICAL
BOX

CEILING

THREADED
STUD

BACKPLATE

2

Always on Emergency Light Wiring (F1E Version Only)

1: Follow wiring diagram in Drawing D to properly install fixture.

2: Connect the hot power wire to the battery & ballast black
wires with a wire nut.

3: Connect the neutral power wire to the battery & ballast white
wires with a wire nut.

4: Connect the quick dis-connect connector together.

D

L

(BLK)

(WH)

N

BATTERY

BALLAST

BATTERY

BALLAST

PRE-CONNECTED
WIRES NOT SHOWN TO
AVOID CONFUSION

2

NOTE:

Follow this step if light will always be on, and in case of

power failure the battery backup will turn the fixture on.

QUICK
DIS-CONNECT
CONNECTOR

NOTE:

Skip this step if installing standard Fluorescent version.

NOTE:

The battery needs to be charged for at least 2 hours.

Perform test after battery is properly charged.

5: Refer to "Finish Installation" steps on page 3 to complete the
installation.

1

3

4

ELECTRICAL
BOX

THREADED
STUD

BACKPLATE

E

BATTERY

BALLAST

PRE-CONNECTED
WIRES NOT SHOWN
TO AVOID CONFUSION

2

Switch Controlled Emergency
Light Wiring (F1E Version Only)

BATTERY

(BLK)

NOTE:

Skip this step if installing standard Fluorescent version.

SWITCH

L1

L2

N

(RED)

(WH)

BALLEST

SWITCH

(BLK)

1: Follow wiring diagram in Drawing E to properly install fixture.

2: Connect the white ballast & battery wires to neutral power
wire with a wire nut.

3: Connect the hot power wire coming from the switch to the
black wires of the ballast with a nut.

4: Connect the other hot power wire to the black wire of the
battery with a wire nut.

5: Connect the quick dis-connect connector together.

NOTE:

Follow this step if light will have an on/of switch, and in

case of power failure the battery backup will turn on.

NOTE:

Two power lines are needed to wire the fixture for this

version.

NOTE:

The battery needs to be charged for at least 2 hours.

Perform test after battery is properly charged.

6: Refer to "Finish Installation" steps on page 3 to complete the
installation.

QUICK
DIS-CONNECT
CONNECTOR

1

3

4

5

Advertising