Finish installation – Edge Lighting Satin Ceiling User Manual
Page 3
3
1: Place all wire and wire nut connections inside backplate.
2: Align and push the fixture housing onto threaded studs and
tighten the three thumb nuts completely to secure the fixture
housing in place.
F
THUMB NUT
ELECTRICAL
BOX
CEILING
THREADED
STUD
BACKPLATE
1
2
2
2
2
Finish Installation
LAMP PIN
SOCKET SLOT
G
FIXTURE
HOUSING
SLOT
SHADE POST
4
4
3
3: Starting with the inner lamp, insert the lamp pins into the
socket slots and secure it in place snapping into the spring
clip(s). Repeat this step for outer lamp (15" and 18" only).
CAUTION:
To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
Use
MAX
22 Watt Type Circline 4-pin T5 2GX13
Base Fluorescent Lamp for 12", 15" and 18"
Satin Ceilings.
Use
MAX
40 Watt Type Circline 4-pin T5 2GX13
Base Fluorescent Lamp for 15" and 18" Satin Ceilings.
NOTE:
The 12" Satin Ceiling uses only one 22 Watt lamp.
4: Insert the three posts of the shade into the fixture housing
slots and turn the shade clockwise to lock into place.
H
NOTE:
To re-lamp the fixture, carefully rotate the glass shade
counter clockwise and remove the shade. Carefully pull the old
lamp(s) out of the socket slot and the spring clip(s). Follow steps 3
to 5 to re-install the lamps and shade.