Edge Lighting Sun3C Ceiling LED Downlight Components - Indoor/Outdoor User Manual
Sun 3 ceiling led (ceiling or wall), Install the sun3 ceiling housing, Installation instructions for
A
HOUSING
WING
NUT
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- This fixture is for wall and ceiling mount only.
Installation Instructions for
Sun 3 Ceiling LED (Ceiling or Wall)
904-SUN3C-03
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
Install the Sun3 Ceiling Housing
1: Carefully pull the trim out of the housing, and remove the
Phillips screw on the tether terminal (safety cable) to release
the trim.
2: Loosen the two top and bottom wing nuts on the housing to
remove the two mounting brackets.
1
© 2012 Edge Lighting. All Rights Reserved.
SUN3C-_
MOUNTING
BRACKET
2
THREADED
STUD
B
HOUSING LIP
WING NUT
MOUNTING
BRACKET
3
THREADED STUD
3: Mount one adjustable mounting bar to the top of the housing
by sliding it completely under the housing lip.
4: Replace the mounting bracket onto the threaded studs so
that the flange faces the adjustable mounting bar. Tighten
the wing nuts to secure the adjustable mounting bar in
place.
5: Repeat steps 2 through 4 for the bottom of the housing.
MOUNTING
BRACKET
FLANGE
4
6:
housing to be mounted.
7: Place the adjustable mounting bars between the studs
(joist).
8: Make sure the lips on the adjustable mounting bars are
against the studs (joist). Secure the adjustable bars to the
studs (joist) with the provided eight #8 screws.
Select the location between the two studs (joist) for the
NOTE:
The adjustable mounting bars mount to joists (studs) that
are spaced 16" to 24" apart.
C
STUD
(JOIST)
ADJUSTABLE
MOUNTING
BAR
8
7
#8 SCREW
8
8
ADJUSTABLE
MOUNTING BAR
5
7
2
TRIM
TETHER
TERMINAL
SCREW
1