Edge Lighting Alpine - Manual

Installation Instructions for
Alpine
904-ALP-W-RD-H1-05
Install the Fixture
1
ALP-W-RD-H1-_ 1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor and outdoor locations.
- RISK OF FIRE:
- This product is for wall mount applications only.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- This product can be dimmed with a standard incandescent
dimmer.
- This instruction shows a typical installation for indoor and
outdoor.
This product must be installed 4 ft above
the ground for wet locations.
IMPORTANT INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Turn power off and allow to cool before replacing lamp.
A
FIXTURE BODY
CANOPY
1: Remove
the fixture body and carefully pull the canopy off of the
fixture body. the two Phillips screws and the silicon washers on
PHILLIPS SCREW
1
1
#8-32 SCREW
CROSSBAR ASSEMBLY
CENTER HOLE
ELECTRICAL BOX HOLE
B
2: Make sure the crossbar assembly is grounded in accordance
with local electrical codes.
3: Feed the power wires through the crossbar assembly
center hole.
4: Mount the crossbar assembly to the electrical box holes with
the provided #8-32 screws.
4
3 4 2
SILICON WASHER
© 2009 Edge Lighting. All Rights Reserved.