Edge Lighting Alpine - Manual (Page 2)

D
E
PHILLIPS SCREW
9
2
FIXTURE
BODY
9: Place all wires and wire nut connections inside the fixture
body. Slide the fixture body completely onto the canopy
and make sure the silicon gasket is in place. Replace and
tighten the two silicon washers and Phillips screws.
10: For installation in wet location, caulk around the fixture
canopy with waterproof construction sealant.
7: Connect the two white fixture wires to the neutral power
wire with a wire nut.
8: Connect the two black fixture wires to the hot power wire
with a wire nut.
8
7
F
1: Remove the metal shade by pulling it off of the socket
springs.
2: Remove the old lamp by rotating it counter clockwise and
unlocking it from the socket.
3: Repeat steps 1 & 2 for other lamp.
G
FIXTURE
BODY
Replace the Lamps
LAMP
METAL SHADE
SOCKET
4: Push the lamp into the large portion of the socket slots and
rotate it clockwise to lock it in place.
5: Slide metal shade onto the socket spring clips to secure it in
place.
6: Repeat 4 & 5 for the other socket.
Use MAX 20 Watt Type GU10 Base PAR16 Line Voltage
Lamp With Each Socket.
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
1
2
LAMP
SOCKET
CANOPY
LARGE PORTION
OF THE
SOCKET SLOT
4
4
5
10
5: Feed the power wires through the canopy center hole,
washer, and nut provided.
6: Slide the canopy back onto the crossbar assembly nipple
(make sure the gasket is in place) and secure the canopy to
the crossbar assembly by tightening the nut.
C
SILICON GASKET
9
SILICON
GASKET
SILICON
WASHER
9
NUT
WASHER
5
6