Edge Lighting Port LED Components - Manual (Page 6)

GROUND
K
TRIM
2
NOTE:
consumes 2.4 watts.
Each fixture contains an integrated LED lamp. Each Port
Wiring the Trims
LOW VOLTAGE WIRE SIZE CHART
TRANSFORMER
WATTAGE WIRE SIZE
FOR UP TO 13 FT
WIRE SIZE
FOR 14-20 FT
WIRE SIZE
FOR 21-34 FT
WIRE SIZE
FOR 34-52 FT
12V 60W
TE-60L-12
#14 AWG #12 AWG #10 AWG #8 AWG
Overall Wiring Diagram
PORT
12V AC (RED)
120V NEUTRAL (WHITE)
120V HOT (BLACK) 12 VAC
POWER SUPPLY
TRIM HOUSING
1: Remove the plastic caps.
2: Connect each trim wire to one power wire in the electrical
box with a wire nut.
3: Place all wire connections inside the electrical box and push
the trim completely into the trim housing opening.
4: Repeat steps 2 and 3 for other trims.
3
NOTE:
(provided) onto the trim to prevent water leaking inside the
electrical box. Use water proof outdoor wire nuts for power
connection.
For outdoor installation, place the water proof gasket
GASKET
GASKET INSTALLATION
FOR OUTDOOR
GASKET
NOTE:
provided with the PORT-LL to install the beam control accessories
in each trim prior to wiring the trims.
If using the PORT-LL accessory, refer to the instruction
6