Edge Lighting Step - Manual (Page 3)

3
Slave Step Kit Wiring
F
1: Run the proper low voltage wires to each housing by referring to the "Low Voltage Wire Size Chart" on page 1. The distances
are from the master housing to each slave housing. Refer to the wiring diagram above before proceeding with the steps
below.
2: Make sure the power to the transformer line voltage wires are off.
3: Starting with the master housing, connect one transformer wire to one low voltage wire going to adjacent slave housing and
to a 1 foot long low voltage pigtail wire with a wire nut.
4: Connect the other transformer wire to the other low voltage wire going to the adjacent slave housing and another 1 foot long
low voltage pigtail wire with a wire nut.
5: Continuing with the adjacent slave housing, connect one of the low voltage wires coming from the preceding housing to
one of the thermal protector wire with a wire nut.
6: Connect the other thermal protector wire to one of the low voltage wires going to the next slave housing and to a 1 foot long
low voltage pigtail wire with a wire nut.
7: Connect the other low voltage wire coming from the preceding housing to the low voltage wire going to the next housing and
another 1 foot long low voltage pigtail wire.
8: Repeat steps 4 through 6 for all other slave housing except the last one.
9: For the last slave housing, connect one low voltage wire coming from the preceding housing to one of the thermal protector
with a wire nut.
10: Connect the other thermal protector wire to a 1 foot long low voltage pigtail wire with a wire nut.
11: Make sure the other low voltage wire coming from preceding housing extends 1 foot out of the slave housing.
1 1
2
3 4
5
6 7
10
HOUSING
MASTER TRIM SLAVE TRIM SLAVE TRIM
THERMAL
PROTECTOR
75W MAX
ELECTRONIC
TRANSFORMER
WHITE (NEUTRAL)
BLACK (HOT)
STEP WIRING DIAGRAM
MASTER SLAVE LAST SLAVE
11
9