Edge Lighting PSB-30W-12VDC, 30 Watt 12 Volt DC Power Supply - Manual (Page 2)

"N" White
"L" Black
" " GREEN T
White +
Black -
"N" White
"L" Black
" " GREEN
White +
Black -
"N" White
"L" Black
" " GREEN
T
White +
Black -
Using LED Power Supply with a Light Switch & Warm White
Soft Strip (Non-Dimmable)
1
remove the cover. : Loosen the six Phillips screws on front of the power supply to
A
B
2: Install conduits from the light switch, main panel (line
voltage) and soft strip to the power supply case.
3: Run proper size wires from the light switch electrical box to
the power supply case.
4: Run the line voltage power wires from the panel to the
power supply case.
1
POWER SUPPLY
ELECTRICAL BOX
CONDUIT
2
4
2
LIGHT SWITCH
COVER
PHILLIPS SCREW
CASE
5: Connect the hot power wire to one of the wires coming
from the switch with a wire nut.
6: Connect the other switch wire to the black power supply
wire marked "L" with a wire nut.
7: Connect the neutral power wire to white power supply wire
marked "N" with a wire nut.
8: Make sure the green transformer wire is grounded in
accordance with local electrical codes.
C
5
6
NOTE: Skip this section if dimming the warm white LED
soft strip or using RGB soft strip.
POWER LINE WIRES
7
8
3