Edge Lighting PSB-60W-12VDC, 60 Watt 12 Volt DC Power Supply - Manual (Page 5)

LED SOFT STRIP
OUTPUTS TO LED MODULES
16
17
18
21
20
15: Use the "Low Voltage Wire Size Chart" on page 1 to
determine the proper wire size connecting the dim module
to the LED soft strip.
16: Run the proper size, red and black wires from the dim
module case to the LED soft strip.
17: Connect the red wire to "+" terminal of dim module
output.
18: Connect the black wire to "-" terminal of dim module
output.
19: Replace the covers of the dim module and secure them by
tightening the Phillips screws.
20: Connect the red wire coming from the dim module to the
red wire of each LED soft strip.
22: Connect the black wire coming from the dim module to
the black wire of each LED soft strip.
K
L
COVER
0-10V Dimming
LED +
LED -
L N G
PHILLIPS SCREW
23
23: Replace the power supply cover and secure it by tightening
the six Phillips screws.
NOTE: Maximum length of a single soft strip to be
connected to power supply before re-feeding is 16'.
NOTE: Use only 12 volt LED soft strip with this power
supply.
Using LED Power Supply with RGB Soft Strip & CDP or CTP
Controller
POWER SUPPLY
M
M
1
COVER
PHILLIPS SCREW
CASE
M
DVR-RGB-60
COVER
2
NOTE: Refer to the instructions provided with the CDP
(Color Dial Controller) or CTP (Color Touch Screen
Controller) to install, power, and program them. This
section shows typical CDP controller installation.
5
1
remove the cover. : Loosen the six Phillips screws on front of the power supply to
NOTE: Use a DVR-RGB-60 (Sold Separately) with this
power supply.
2: Carefully pull off the cover from the DVR-RGB-60 driver.
(Sold-Separately).