Edge Lighting PSB-60W-12VDC, 60 Watt 12 Volt DC Power Supply - Manual (Page 6)

6
M
N
ELECTRICAL BOX
CONDUIT
9
8
CONTROLLER
CONTROLLER
POWER SUPPLY
O
10: Connect one end of a data wire (blue with white stripes
wire) to controller "DMX –" terminal. Connect the other end
into the DVR-RGB-60 "DMX in –" terminal.
11: Connect one end of a data wire (white with blue stripes
wire) to controller "DMX +" terminal. Connect the other end
into the DVR-RGB-60 "DMX in +" terminal.
12: Connect one end of a data wire (bare shield wire) to
controller "DMX shield" terminal. Connect the other end into
the DVR-RGB-60 "DMX in shield" terminal.
M
12
11
10
P
M
CONDUIT
14
15
16
13: Run the line voltage power wires into the power supply.
14: Connect the hot power wire to yellow power supply wire
marked "L" and black wire coming from the controller
power supply with a wire nut.
15: Connect the neutral power wire to black power supply wire
marked "N" and white wire coming from the controller
power supply with a wire nut.
16: Make sure the green transformer wire is grounded in
accordance with local electrical codes.
DMX CABLE (BELDEN #9841)
3: Connect a red wire from "+24VDC" of controller terminal to
"+24VDC" of controller power supply terminal.
4: Connect a black wire from "Ground" of controller terminal
"-24VDC" of controller power supply terminal.
5: Run black and white wires from the controller power supply
to the power supply case.
6: Connect the white wire to "N" terminal of the controller
power supply.
7: Connect the black wire to "L" terminal of the controller
power supply.
8: Install conduits from controller, main panel (line voltage),
and soft strip to power supply.
9: Run proper DMX cable (Belden #9841 recommended)
with three data wires from controller to the power supply
box.
NOTE: Use a deep double gang boxes to fit the controller
and controller power supply (OT-20-120-240-245
recommended).
3
4
7
6
5