FASS FA F16 220G User Manual
Page 13
Advertising
VERY IMPORTANT: REMEMBERING THE POSITION OF THE “T” PORT, THERE IS A SMALL WEEP HOLE IN
THE BASE DIRECTLY NEXT TO THE ELECTRIC MOTOR, THIS HOLE MUST AIM DIRECTLY TO THE
GROUND!! IMPROPER INSTALLATION OF THE PUMP CAN CAUSE PREMATURE WEAR AND VOID MANU-
FACTURES WARRANTY.
F.
Disconnect the factory power plug to the HFCM lift pump. Clean plug and install the WE-1006 exten-
sion connector. Plug female plug of the WH-1002 harness into pump. Reconnect the battery. Turn
key on. With pump operating, liberally spray WD-40 (or equivalent) into the “T” port. This process
helps lubricate the gear for easier initial priming.
Advertising