FASS FA C09 260G User Manual
Page 12
K.
With proper length being obtained with the suction tube, de-bur and
flush assembly. Slide tube through hole, lock washer, and nut. Make
sure O-ring on bottom of bulkhead fitting remains in it’s groove.
With BHF-1002 properly seated against tank, tighten nut.
L.
Carefully re-install pick up module. Do not bend Fuel Level Arm.
J.
Place the suction tube assembly into the hole. Take measurements so
the bottom of the suction tube is only 1/8” (no more than 2 quarters
stacked) from the bottom of the fuel tank. Before cutting the suction
tube, triple check the measurements. It is more efficient to cut the
tube too long and then correct to proper length than it would be to cut
too short.
M.
Attach fuel line to Push-Lok fitting. Remember to oil the fitting and
fuel line. Route fuel line over frame rail when reinstalling fuel tank.
N.
Reinstall fuel tank. Remember to reconnect factory suction line, return line and electrical harness.
Torque tank hanger bolts to proper specifications. Reattach filler neck and clamps.