FASS FA C09 260G User Manual
Page 9
Advertising
E. If fuse panel is located in the cab it will be necessary to guide the single
red wire from the relay through the fire wall grommet to access the fuse pan-
el.
G.
Route WH-1006 wire harness along frame rail to mounting location of pump. Completion of this step
will be addressed in the Mounting Step 3.
F.
Locate fuse box under hood and select ignition hot fuse. Remove fuse and put Add-A-Fuse in place.
Install fuse previously removed. The use of a corrosion preventative on electrical connections is
recommended.
Note: The FASS harness provided has a 15 amp fuse and the 30 amp fuse provided
loose in the kit is to be installed on the wiring harness due to the volume and torque
the FASS pump is producing.
Advertising