FASS FA C09 260G - Manual (Page 13)

Note: Use of Anti-seize compound is highly recommended.
B. Secure THB-1001 to bolt on bracket with the RS 1002 and the (2)– 1/4-20x1 bolts, 1/4 washers, and 1/4
nuts. With the (4)-1/4-20x1.75” bolts thread the BHB-1001 to the THB-1001.
A. Locate bed bolt and remove the bolt. Position RS-2001 between FPB-2005 and truck bed.
C. Using thread tape, install the 2 10-300 into the “T” & “E” ports. Torque to 40 ft./lbs. Connect the male
end of the wire harness to the female electrical connector on the FASS pump. Reconnect the battery.
Turn key to the “On” position. With the FASS pump on, squirt a liberal amount of WD-40 or other
lubricant into the “T” port. This procedure will “wet” the Gerotor and allow for better suction during
initial priming.
Note: Do Not Put Thread Tape on Flare of Fitting