FASS FA C09 260G - Manual (Page 15)

A. Route suction line from Step 2L to port ‘T’. Cut FL-1002 to needed
length. Using oil, insert PL-1005 and connect to 10-300 in port ’T’.
Torque to 18 ft./lbs.
B. Install in-line fuel filter in an accessible location in the suction line
using the HC-1001’s. Making sure the fuel flow travels the direction
of the arrow on the canister.
E. Reassemble fuel cooler on 2001-2010 models.
D. Using an HC-1001 hose clamp, insert the QD-1002 into the other end of the provided FL-1002 fuel line
and secure. Oil the rings inside the QD-1002 and slide over the factory feed line until you hear a click.
Cap factory suction line and secure.
2001-2010
2011-Present
C. Using oil, insert PL-1005 into FL-1002 fuel line. Connect to the ‘E’
port of the FASS pump. Torque to 18 ft./lbs. Measure fuel line to the
factory feed line disconnected in Step 2c and cut.
Note: Inline filter will need to be replaced every 6,000 miles.