Canon ImageCLASS MF8180c User Manual
Page 17
- 17 -
Specifying Automatic Network Settings (dynamic allocation):
NOTE
●
This machine is set by default to automatically draw an IP using DHCP. If your
network server or router is configured to provide a DHCP address all you need to
do is connect a network cable and power on the printer. The printer will draw an
IP address automatically.
●
This machine also supports automatic IP addresses using BOOTP and RARP
protocols. For definitions and an explanation of each please refer to the Network
Guide. Use the following instructions to change the protocol to BOOTP or RARP if
necessary.
●
If you are using Static IP addresses on your network proceed to
1 Press [Menu]
➝
or
(arrow keys) to select <6.NETWORK SETTINGS> on the LCD
➝ press [Set].
2 Press
or
(arrow keys) to select <1.LAN SETTINGS>
➝ press [Set].
3 Press
or
(arrow keys) to select <1.IP ADDRESS AUTO.>
➝ press [Set].
4 Press
or
(arrow keys) to select <ON>
➝ press [Set].
5 Press
or
(arrow keys) to select <1.DHCP>, <2.BOOTP>, or <3.RARP>
➝ press
[Set].
NOTE
●
For information on each protocol, see the glossary in Chapter 3,“Appendix,” in the Network Guide.
6 Press
or
(arrow keys) to select <ON>
➝ press [Set].
7 Press [Stop/Reset] to return to the standby display.
8 Turn the machine off by disconnecting the power cord. Connect the network cable as
described in step
. Turn the machine back on by plugging the power cord back in.
Proceed to step
.
Set key
Menu
Menu
Set
Set
Stop/Reset
Stop/Reset
Menu key
Arrow keys
Stop/Reset key