NISSAN 2012 370Z Roadster - Owner's Manual - Manual (Page 115)

button - releasing when the device begins to
activate.
5. If the indicator light on HomeLink ® blinks
rapidly for two seconds and then turns solid,
HomeLink
® has picked up a “rolling code”
garage door opener signal. You will need to
proceed with the next steps to train
HomeLink
® , completing the programming
may require a ladder and another person
for convenience.
6. Push and release the program button
located on the garage door opener’s motor
to activate the “training mode”. This button is
usually located near the antenna wire that
hangs down from the motor. If the wire
originates from under a light lens, you will
need to remove the lens to access the
training button.
NOTE:
Once you have pushed and released
the training button on the garage door
opener’s motor and the “training light”
is lit, you have 30 seconds in which to
perform step 7. For convenience, use
the help of a second person to assist
when performing this step.
7. Quickly (within 30 seconds of pushing and
releasing the garage door opener training
button) and firmly push and release the
HomeLink ® button you have just pro-
grammed. Push and release the HomeLink ®
button up to three times to complete the
training.
8. Your HomeLink ® button should now be
programmed. To program the remaining
HomeLink
® buttons for additional door or
gate openers, follow steps 2 through 8 only.
NOTE:
Do not repeat step 1 unless you want to
“ c l e a r ” a l l p r e v i o u s l y p r o g r a m m e d
HomeLink
® buttons.
If you have any questions or are having difficulty
programming your HomeLink
® buttons, please
refer to the HomeLink ® web site at: www.
homelink.com or call 1-800-355-3515.
PROGRAMMING HomeLink
®
FOR CA-
NADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmitting after
2 seconds. To program your hand-held trans-
mitter to HomeLink
® , continue to push and hold
the HomeLink ® button (note steps 2 through 4
under “Programming HomeLink ® ”) while you
push and re-push (“cycle”) your hand-held
transmitter every 2 seconds until the indicator
light flashes rapidly (indicating successful pro-
gramming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damage to the garage door opener com-
ponents.
OPERATING THE HomeLink
®
UNIVER-
SAL TRANSCEIVER
HomeLink ® Universal Transceiver (once pro-
grammed) may now be used to activate the
garage door, etc. To operate, simply push the
appropriate programmed HomeLink
® Universal
Transceiver button. The red indicator light will
illuminate while the signal is being transmitted.
PROGRAMMING TROUBLE-DIAGNO-
SIS
If HomeLink ® does not quickly learn the hand-
held transmitter information:
. replace the hand-held transmitter batteries
with new batteries.
. position the hand-held transmitter with its
battery area facing away from the
HomeLink
® surface.
. push and hold both the HomeLink ® and
hand-held transmitter buttons without inter-
ruption.
. position the hand-held transmitter 2 to 5 in
(50 to 127 mm) away from the HomeLink ®
Instruments and controls 2-51