Caution – NISSAN 2012 370Z Roadster - Owner's Manual User Manual

Page 364

Advertising
background image

8-12

Maintenance and do-it-yourself

SDI2335

Engine oil and filter

1. Place a large drain pan under the drain plug.

2. Remove the oil filler cap.

3. Remove the drain plug

*

1

with a wrench

and completely drain the oil.

CAUTION

Be careful not to burn yourself, as the
engine oil is hot.

.

Waste oil must be disposed of

properly.

.

Check your local regulations.

(Perform steps 4 to 7 only when the engine
oil filter change is needed.)

4. Loosen the oil filter

*

2

with an oil filter

wrench. Remove the oil filter by turning it by
hand.

5. Wipe the engine oil filter mounting surface

with a clean rag.

CAUTION

Be sure to remove any old rubber
gasket remaining on the mounting sur-
face of the engine. Failure to do so
could lead to engine damage.

6. Coat the gasket on the new filter with clean

engine oil.

7. Screw in the oil filter clockwise until a slight

resistance is felt, then tighten additionally
more than 2/3 turn.
Oil filter tightening torque:

11 to 15 ft-lb
(14.7 to 20.5 N·m)

8. Clean and re-install the drain plug with a

new washer. Securely tighten the drain plug
with a wrench.

Drain plug tightening torque:

22 to 29 ft-lb
(29 to 39 N·m)

Do not use excessive force.

9. Refill engine with recommended oil through

the oil filler opening, and install the oil filler
cap securely.

See “Capacities and recommended fuel/
lubricants” (P.9-2) for drain and refill capa-
city. The drain and refill capacity depends on
the oil temperature and drain time. Use
these specifications for reference only. Al-
ways use the dipstick to determine the
proper amount of oil in the engine.

10. Start the engine and check for leakage

around the drain plug and the oil filter.
Correct as required.

11. Turn the engine off and wait more than 15

minutes. Check the oil level with the dipstick.
Add engine oil if necessary.

After the operation

1. Install the engine undercover into position as

the following steps.

a. Pull the center of the small plastic clip

out.

b. Hold the engine undercover into position.

Advertising
This manual is related to the following products: