For nismo models -16 – NISSAN 2012 370Z Roadster - Owner's Manual User Manual

Page 410

Advertising
background image

9-16

Technical and consumer information

FOR NISMO MODELS

Use the following steps to mount the license
plate:

Before mounting the license plate, confirm that
the following parts are enclosed in the vinyl bag.
. License plate bracket
. J-nut 6 2
. Screw 6 4
. Screw grommet 6 4
1. Park the vehicle on flat, level ground.

2. Temporarily place the license plate bracket

while aligning points

*

A

of the front bumper

fascia with holes

*

B

in the license plate

bracket.

3. Confirm that points

*

A

and

*

B

are aligned.

Hold the license plate bracket and mark the
points

*

C

on the bumper facia through the

center of the holes

*

D

with a felt-tip pen.

4. Remove the license plate bracket.

5. Carefully drill two shallow pilot holes

*

A

and

*

C

using a 0.39 in (10 mm) drill bit at

the marked locations. (Be sure that the
drill only goes through the fascia.)

6. Insert grommets into the hole on the fascia.

7. Insert a flat-blade screwdriver into the

grommet hole to add a 90

8 turn onto the

part

*

E

.

8. Insert a J-nut into the license plate bracket

before placing the license plate bracket on
the fascia.

9. Install the license plate bracket with the

screws.

10. Install the license plate with bolts that are

not longer than 0.55 in (14 mm).

When the recovery hook is used, you need to
temporarily remove the front license plate and
bracket from the vehicle. (See “Vehicle recovery
(freeing a stuck vehicle)” (P.6-21) for further
details.)

STI0623

Left side

This vehicle is equipped with air deflectors in
front of the front wheels. The deflectors will
change the air flow to help improve aerodynamic
performance.

When transporting your vehicle on a trailer, the
air deflectors may interfere with a steep slope to
a trailer bed. In this case, remove the deflectors
from the undercover of the vehicle.

1. Loosen three screws as shown and remove

the left-side air deflector

*

A

.

2. Tighten the removed screw

*

B

in its

original position.

3. Perform the same procedure to remove the

right-side air deflector.

REMOVING AIR DEFLECTORS
(except for NISMO models)

Advertising
This manual is related to the following products: