Programming homelink – NISSAN 2015 370Z Roadster - Owner's Manual User Manual
Page 116
reverse features as required by
federal safety standards. (These
standards became effective for
opener models manufactured after
April 1, 1982). A garage door opener
which cannot detect an object in the
path of a closing garage door and
then automatically stop and reverse,
does not meet current federal safety
standards. Using a garage door
opener without these features in-
creases the risk of serious injury or
death.
. During the programming procedure
your garage door or security gate
will open and close (if the transmit-
ter is within range). Make sure that
people or objects are clear of the
garage door, gate, etc. that you are
programming.
. Your vehicle’s engine should be
turned off while programming the
HomeLink
Universal Transceiver.
Do not breathe exhaust gases; they
contain colorless and odorless car-
bon monoxide. Carbon monoxide is
dangerous. It can cause uncon-
sciousness or death.
PROGRAMMING HomeLink
If you have any questions or are having difficulty
programming your HomeLink
buttons, refer to
the HomeLink
web site at: www.homelink.com
or call 1-800-355-3515.
NOTE:
It is also recommended that a new battery
be placed in the hand-held transmitter of
t h e
d e v i c e
b e i n g
p r o g r a m m e d
t o
HomeLink
for quicker programming and
accurate transmission of the radio-fre-
quency.
1. Position the end of your hand-held transmit-
ter 1-3 in (26-76 mm) away from the
HomeLink
surface, keeping the HomeLink
indicator light
*
1
in view.
JVI0428X
2. Using both hands, simultaneously press and
hold the desired HomeLink
button and
handheld transmitter button. DO NOT re-
lease until the HomeLink
indicator light
*
1
flashes slowly and then rapidly. When the
indicator light flashes rapidly, both buttons
may be released. (The rapid flashing indi-
cates successful programming.)
NOTE:
Some devices to be programmed may
require you to replace Step 2 with the
cycling procedure noted in the “Pro-
gramming HomeLink
for Canadian
customers and gate openers” (P.2-52).
Instruments and controls
2-51