Nissan vehicle immobilizer system -29 – NISSAN 2015 370Z Roadster - Owner's Manual User Manual

Page 94

Advertising
background image

SIC2045

How to arm the vehicle security system

1. Close all windows.

The system can be armed even if the
windows are open.

2. Push the ignition switch to the OFF position.

3. Remove the Intelligent Key from the vehicle.

4. Close all doors, hood and rear hatch/trunk.

Lock all doors and trunk (Roadster models).
The doors can be locked with the Intelligent
Key, door handle request switch, power
door lock switch or mechanical key.

5. Confirm that the security indicator light

comes on. The security indicator light stays
on for about 30 seconds. The vehicle

security system is now pre-armed. After
about 30 seconds the vehicle security
system automatically shifts into the armed
phase. The security light begins to flash
once every approximately 3 seconds. If,
during this 30-second pre-arm time period,
the door is unlocked, or the ignition switch is
pushed to ACC or ON, the system will not
arm.

Even when the driver and/or passengers
are in the vehicle, the system will activate
with all doors, hood and rear hatch locked
with the ignition switch in the LOCK
position. When pushing the ignition switch
to the ACC or ON position, the system will
be released.

Vehicle security system activation

The vehicle security system will give the follow-
ing alarm:
. The headlights blink and the horn sounds

intermittently.

. The alarm automatically turns off after

approximately 1 minute. However, the alarm
reactivates if the vehicle is tampered with
again.

The alarm is activated by:
. Unlocking the door or opening the rear

hatch without using the button on the

Intelligent Key, the door handle request
switch or the mechanical key. (Even if the
door is opened by releasing the door inside
lock knob, the alarm will activate.)

. Opening the hood.

How to stop an activated alarm

The alarm will stop by unlocking a door by
pushing the unlock button on the Intelligent Key,
the door handle request switch or using the
mechanical key. The alarm will not stop if the
ignition switch is pushed to the ACC or ON
position.

If the system does not operate as de-
scribed above, have it checked by a
NISSAN dealer.

NISSAN VEHICLE IMMOBILIZER SYS-
TEM

The NISSAN Vehicle Immobilizer System will not
allow the engine to start without the use of the
registered Intelligent Key. Never leave these
keys in the vehicle.

For USA:

This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:

(1) This device may not cause harmful
interference, and (2) this device must

Instruments and controls

2-29

Advertising
This manual is related to the following products: