NISSAN 2015 370Z Roadster - Owner's Manual - Manual (Page 118)

indicator light will flash slowly and then rapidly
after several seconds upon successful program-
ming. DO NOT release until the HomeLink
Š
indicator light flashes slowly and then rapidly.
When the indicator light flashes rapidly, both
buttons may be released. The rapid flashing
indicates successful programming.
Proceed with “Programming HomeLink Š ” step 3
to complete.
Remember to plug the device back in when
programming is completed.
OPERATING THE HomeLink
Š
UNIVER-
SAL TRANSCEIVER
The HomeLink Š Universal Transceiver, after it is
programmed, can be used to activate the
programmed device. To operate, simply press
and release the appropriate programmed
HomeLink
Š
Universal Transceiver button. The
amber indicator light will illuminate while the
signal is being transmitted.
For convenience, the hand-held transmitter of
the device may also be used at any time.
PROGRAMMING TROUBLESHOOT-
ING
If the HomeLink Š does not quickly learn the
hand-held transmitter information:
. replace the hand-held transmitter batteries
with new batteries.
. position the hand-held transmitter with its
battery area facing away from the
HomeLink
Š surface.
. press and hold both the HomeLink Š and
hand-held transmitter buttons without inter-
ruption.
. position the hand-held transmitter 1-3 in
(26-76 mm) away from the HomeLink Š
surface. Hold the transmitter in that position
for up to 15 seconds. If HomeLink
Š is not
programmed within that time, try holding the
transmitter in another position - keeping the
indicator light in view at all times.
If you have any questions or are having difficulty
programming your HomeLink
Š buttons, refer to
the HomeLink
Š
web site at: www.homelink.com
or 1-800-355-3515.
CLEARING THE PROGRAMMED IN-
FORMATION
The following procedure clears the programmed
information from both buttons. Individual buttons
cannot be cleared. However, individual buttons
can be reprogrammed, see “Reprogramming a
single HomeLink
Š
button” (P.2-53).
To clear all programming
1. Press and hold the two outer HomeLink Š
buttons until the indicator light begins to
flash in approximately 10 seconds. Do not
hold for longer than 20 seconds.
2. Release both buttons.
HomeLink
Š
is now in the programming mode
and can be programmed at any time beginning
with “Programming HomeLink
Š ” - Step 1.
REPROGRAMMING A SINGLE
HomeLink
Š BUTTON
To reprogram a HomeLink Š Universal Transcei-
ver button, complete the following.
1. Press and hold the desired HomeLink
Š
button. DO NOT release the button.
2. The indicator light will begin to flash after 20
seconds. Without releasing the HomeLink
Š
button, proceed with “Programming
HomeLink
Š ” - Step 1.
For questions or comments, contact HomeLink Š
Instruments and controls 2-53