NISSAN 2014 Cube - Owner's Manual - Manual (Page 174)

setting.
AUDIO button:
Push the AUDIO button to change the selecting
mode as follows.
Push the TUNE ( , ) or SEEK ( , )
button to adjust Bass and Treble to the desired
level. Use the TUNE or SEEK button also to
adjust Fade or Balance modes. Fade adjusts the
sound level between the front and rear speakers
and Balance adjusts the sound between the
right and left speakers.
To turn the beep sound off or on, push the TUNE
or SEEK button until the desired mode is
displayed. This turns on or off the beep sound
when audio buttons are pushed.
To change the Speed Sensitive Volume (Spd
Sen Vol) mode to OFF, LOW, MID or HIGH,
push the TUNE or SEEK button until the desired
mode is displayed.
Once you have adjusted the sound quality to the
desired level, push the AUDIO button repeatedly
until the normal mode display reappears. Other-
wise, the normal mode display will automatically
reappear after approximately 5 seconds.
CLOCK button:
Push the CLOCK button to turn on or off the
CLOCK display.
SIC4131
Push the CLOCK button
*
1 to turn the clock on
or off.
1. Push and hold the CLOCK button
*
1 until
the clock display starts to flash.
2. Push the SEEK/TRACK button
*
2 to adjust
the hours.
3. Push the TUNE/FF·REW button
*
3 to
adjust the minutes.
4. Push the CLOCK button
*
1 again to exit
the clock set mode.
The display will return to the regular clock
display after 5 seconds.
Center display, heater, air conditioner, audio and phone systems 4-33
setting.
AUDIO button:
Push the AUDIO button to change the selecting
mode as follows.
Push the TUNE ( , ) or SEEK ( , )
button to adjust Bass and Treble to the desired
level. Use the TUNE or SEEK button also to
adjust Fade or Balance modes. Fade adjusts the
sound level between the front and rear speakers
and Balance adjusts the sound between the
right and left speakers.
To turn the beep sound off or on, push the TUNE
or SEEK button until the desired mode is
displayed. This turns on or off the beep sound
when audio buttons are pushed.
To change the Speed Sensitive Volume (Spd
Sen Vol) mode to OFF, LOW, MID or HIGH,
push the TUNE or SEEK button until the desired
mode is displayed.
Once you have adjusted the sound quality to the
desired level, push the AUDIO button repeatedly
until the normal mode display reappears. Other-
wise, the normal mode display will automatically
reappear after approximately 5 seconds.
CLOCK button:
Push the CLOCK button to turn on or off the
CLOCK display.
SIC4131
Push the CLOCK button
*
1 to turn the clock on
or off.
1. Push and hold the CLOCK button
*
1 until
the clock display starts to flash.
2. Push the SEEK/TRACK button
*
2 to adjust
the hours.
3. Push the TUNE/FF·REW button
*
3 to
adjust the minutes.
4. Push the CLOCK button
*
1 again to exit
the clock set mode.
The display will return to the regular clock
display after 5 seconds.
Center display, heater, air conditioner, audio and phone systems 4-33