NISSAN 2014 GT R - Owner's Manual - Manual (Page 317)

8-46 Maintenance and do-it-yourself
5. Remove the wheel nuts and then remove the
wheel.
NOTE:
When putting a wheel on the ground,
put it down with the outer side of the
wheel facing up to prevent scratching
of the wheel surface.
6. Clean any mud or dirt from the surface
between the brake disc rotor
*
1 and wheel
*
2 .
7. Tighten the wheel nuts by hand by turning
them clockwise until the tapered part
*
A of
each nut lightly contacts the seat part
*
B of
the wheel hole.
When replacing a front wheel, make sure the
hole in the wheel is aligned with the pin on
the brake disc rotor.