NISSAN 2015 GT R - Owner's Manual - Manual (Page 146)

USING THE WIPERS
Push the lever down to operate the wiper at the
following speed:
*
1 INT (Intermittent) — intermittent operation can
be adjusted by turning the knob toward
*
A
(Slower) or
*
B (Faster).
*
2 Low — continuous low speed operation
*
3 High — continuous high speed operation
Push the lever up *
4 to have one sweep
operation of the wiper.
NOTE:
.
In the MIST position, the wipers oper-
ate while the lever is lifted up. When
the lever is released, it automatically
returns to the OFF position and the
wipers stop.
. When the speed sensing wiper interval
function is turned on, the intermittent
operation speed varies in accordance
with the vehicle speed. (For example,
when the vehicle speed is high, the
intermittent operation speed will be
faster.) To turn this function on and
off, see the separate Multi Function
Display Owner’s Manual.
. If the wiper operation is interrupted by
snow or ice, the wiper may stop moving
to protect its motor. If this occurs, turn
the wiper switch to the OFF position
and remove the snow or ice on and
around the wiper arms. In approxi-
mately 1 minute, turn the switch on
again to operate the wiper.
USING THE WASHER
Pull the lever toward you to operate the washer.
Then the wiper will also operate several times.
NOTE:
When the level of washer fluid is low, a
warning display appears on the vehicle
information display. (
“Low washer
fluid warning” page 2-42)
Instruments and controls 2-49