NISSAN 2015 GT R - Owner's Manual - Manual (Page 211)

5-14 Starting and driving
1. Check the positions of the accelerator pedal
*
1 and brake pedal *
2 . Adjust the steering
wheel and seat positions so that the correct
driving posture is achieved. (
“Front
seats” page 1-3)
2. Check that the parking brake is engaged.
3. Check that the shift lever is in the
& P or & N
position. ( & P is recommended.)
4. Firmly depress the brake pedal. Without
depressing the accelerator pedal, push the
ignition switch once to start the engine.
5. To stop the engine, move the shift lever to
the & P position, and push the ignition switch
to the OFF position.
NOTE:
.
Care should be taken to avoid situa-
tions that can lead to potential battery
discharge and potential no-start condi-
tions such as:
a. Installation or extended use of elec-
tronic accessories that consume
battery power when the engine is
not running (Phone chargers, GPS,
DVD players, etc.)
b. Vehicle is not driven regularly and/
or only driven short distances.
In these cases, the battery may need to
be charged to maintain battery health.
. If the engine is difficult to start, de-
press the accelerator pedal all the way
to the floor and hold it. Push the
ignition switch with the brake pedal
depressed to start cranking the engine.
After 5 or 6 seconds, stop cranking by
pushing the ignition switch to the OFF
position, and then release the accel-
erator pedal. Then perform steps 1 to 5
to start the engine. If the engine starts,
but fails to run, repeat this procedure.
. Starting and stopping the engine over a
short period of time may make the
vehicle more difficult to start. If this
occurs, wait for more than 3 minutes,
and then push the ignition switch again
to start the engine.
. To maintain high performance over a
long period of time, the engine speed is
limited to 5,000 rpm when the engine is
revved with the shift lever in the
& N or
& P position, and to 4,000 rpm when the
engine oil or coolant temperature is
low or higher than normal.
. If the ignition switch is pushed before
the shift lever is moved to the
& P
position, the ignition switch will not
change to the OFF position. If this
occurs, the SHIFT
& P warning display
appears on the vehicle information
display. When stopping the engine, be
sure to move the shift lever to the
& P
position and then push the ignition
switch. Failure to do so may result in
discharge of the battery. (
“Shift
“P” warning” page 2-43)
. If the shift lever was in the & A
ņ & M or & R
position when the engine was stopped,
then be sure to move the shift lever to
the
& P position before starting the
engine the next time. If the engine is
started with the shift lever in the
& N
position, then it may not be possible to